VIDENT iEasy320 Vehicles Coverage:
As a general rule it covers most cars as:
Some Japanese Petrol/Diesel cars made from 2000
European Petrol cars from 2001
European Diesel Cars from 2004
Holden from 2006
Subaru(engine codes) from 2003
Support all the 10 OBDII test modes
Red-Yellow-Green LEDs and build-in speaker indicate emissions monitor status.
They can also help catch intermittent problems or confirm repairs during a drive cycle.
I/M readiness hot keys make it easy to use this tool right out of the package.
Quick display of status of all tests on a single screen
Read/ clear stored & pending codes, switch off Check Engine Light (MIL) and resets monitors
View on-screen fault code definitions (Generic, manufacturer specific, pending and permanent,
where available) - thousands of definitions stored within the tool software
Look up fault code definitions from the tool's on-board database
Read freeze-frame data engine conditions such as fuel trim, engine coolant temp, etc.,
at the time the Malfunction Indicator Lamp (MIL) was set(a snapshot of sensor values
when a DTC occurred)
Read, records, graphs & playbacks real-time live data streams from the engine sensors- ideal for monitoring intermittent faults
Graph live engine data on-screen
View Oxygen Sensor test results (dependent on vehicle support)
View on board monitor test and component test
Retrieve protocol, VIN, Cal ID and CVN identifiers from ECU (dependent on vehicle support)
Enhanced Mode 6 functions—Non-continuously Monitored Systems test results.
Automatic VIN acquisition and decoding makes it much easier to read manufacturer specific codes and enhanced mode 6 data
Test and display the voltage of battery.
Support max. 4 graphic comparisons of data stream